Adera BETOPRIMER

Instructions for use:

Surface preparation:
The surfaces must be dry, frost-free, clean, without efflorescence, loosen parts and traces of separating agent.

Application:
The product is slowly mixed in the bucket with the mixer at low speed, the application consistency being optionally adjusted by a small amount of water. Apply using a brush or roller. It is also suitable for mechanical application. Let it dry for at least 12 hours depending on the air temperature and the support. The gypsum plaster can be applied when ADERA BetoPrimer is completely dry, and no longer sticky.
The temperature of the substrate, air and material must be above 5°C during application and drying time. Low temperatures and high humidity can significantly increase the drying times. In the bucket, the quartz sand deposits must be remixed. When applied, the rules and regulations in force will be observed.

On concrete surfaces with visible humidity (e.g. condensate water) or concrete with a moisture content higher than 4% of weight, plastering is not recommended.